Conejo Services - Internal Map of California

Install

Sales- Greg

Turn- N/A

40 gallon water heater

Sales-Kevin**Send Krista water heater label or upload to acct**Call Kevin for specs-805-796-8502 bring extra sheet metal**

40-Gallon Gas Water Heater Replacement

Replacement of an existing 40-gallon gas water heater in a garage with no recirculation pump.

Location: Garage

Recirculation Pump: No

Tasks:

Preparation and Shutoff:

1. Shut off gas supply valve

2. Close main water supply

3. Drain existing water heater to empty tank

Removal of Existing Unit:

1. Disconnect gas line from heater

2. Detach cold and hot water supply lines

3. Remove and dispose of old unit per local regulations

New Water Heater Installation:

1. Position new 40-gallon unit with adequate clearance per code

2. Install new drain pan beneath unit

3. Connect new stainless steel water supply lines (cold and hot)

4. Install 1/4-turn ball valve on cold water inlet

5. Install expansion tank, adjusted to home water pressure (typically 50-60 PSI)

6. Fit new gas shutoff valve on gas line

7. Attach new flexible gas supply line with sediment trap

8. Secure unit with Unistrut mounting and earthquake straps

9. Reconnect to existing T&P relief valve exit point

10. Insulate water supply lines for efficiency

11. Install copper bonding wire from water lines to gas line for grounding

12. Before setting in new water heater plumbers will sheet metal up to h the top of the water heater on all three sides of the water heater closet and up in the ceiling around the venting to try and prevent rodents from entering water heater closet (Conejo services is providing a service to attempt to try and keep rodents out of the water heater closet, this is not a permanent solution as rats and or rodent have soft bone structures and can get through any cracks or gaps) Conejo is simply trying to help customer.

Venting and Combustion:

1. Install venting per manufacturer’s specs (e.g., double-wall or single-wall as required)

2. Secure single-wall vent connections with 3 screws each

3. Verify adequate combustion air supply per code

Testing and Startup:

1. Pressure-test gas and water connections for leaks

2. Fill tank and purge air from lines

3. Test T&P relief valve operation

4. Light pilot, set temperature to 120°F (or per client preference), and confirm burner ignition

5. Validate full operational status

Cleanup and Final Steps:

1. Clear debris from work area

2. Haul away old unit for disposal

3. Conduct final inspection with client walkthrough

Notes:

- Estimate valid for 30 days from issuance

- Permit fees, if required, are included as a separate line item

- Unforeseen issues or additional work will be quoted separately with client approval

- Exclusions: Drywall, paint, stucco, tile, concrete, stone repairs, or existing water damage

- Duration: 3-4 hours, 1 technician

- Warranty: Manufacturer - 6 years parts, 1 year labor.

- Qualifies for applicable utility rebates and federal tax credits (where available)

CC or Check $3000.00

Install **8AM SHARP NEEDED **MUST INSTALL SURGE PROTECTORS!

Sales- Greg

Turn- Parker

BEDROOM SYSTEM- 4TON horiz. R802VA furnace/coil in attic, BOVA15

MAIN HOUSE- 4TON horiz. R802VA furnace/coil in attic, BOVA15

Total due - $31,000.00 *Synchrony 18 months*