Conejo Services - Internal Map
We service the Ventura, Los Angeles, and Santa Barbara Counties and surrounding areas. Reach out to us if you’d like a consultation, (805) 232-5559
Our Work
Alan Lueders - $12000 - 2/10/20, CA
Install *PRE 7AM
Sales- Kevin McNerney
Turn- N/A
Upflow furnace, coil, A/C, duct mod/sealing
Total - $12,000.00 (office has CC)
- HVAC
- HVAC: HVAC Install
- Price Ranges
- Price Ranges: 10000 - 15000
- Date Ranges
- Date Ranges: 2020 - Q1
Simon and Karen Hotchin, CA
Install
Sales- Jesse Cruz
Turn- N/A
Add on single-head mini split (Bosch)
Total - $8,500.00 (CC or check)
*THIS WAS THE ONE DAY THAT WORKED FOR HOMEOWNER
Installation **PRE 7AM
Sales- Greg
Turn- John
5TON Upflow S8V2 furnace, coil, BOVB18 A/C, ducting 7-8 runs, NO thermostatDeposit - $1,000.00 AMEXTotal due - $23,890.00 AMEX
Sales-KevinPLEASE SEND KRISTA A PIC OF THE WATER HEATER LABEL OR UPLOAD TO ACCT
50-Gallon Gas Water Heater Replacement
Replacement of an existing 50-gallon gas water heater in a garage with no recirculation pump.
Location: Garage
Recirculation Pump: No
Tasks:
Preparation and Shutoff:
1. Shut off gas supply valve
2. Close main water supply
3. Drain existing water heater to empty tank
Removal of Existing Unit:
1. Disconnect gas line from heater
2. Detach cold and hot water supply lines
3. Remove and dispose of old unit per local regulations
New Water Heater Installation:
1. Position new 50-gallon unit with adequate clearance per code
2. Install new drain pan beneath unit
3. Connect new stainless steel water supply lines (cold and hot)
4. Install 1/4-turn ball valve on cold water inlet
5. Install expansion tank, adjusted to home water pressure (typically 50-60 PSI)
6. Fit new gas shutoff valve on gas line
7. Attach new flexible gas supply line with sediment trap
8. Secure unit with Unistrut mounting and earthquake straps
9. Reconnect to existing T&P relief valve exit point
10. Insulate water supply lines for efficiency
11. Install copper bonding wire from water lines to gas line for grounding
12. Cover base/stand with sheet metal for protection
Venting and Combustion:
1. Install venting per manufacturer's specs (e.g., double-wall or single-wall as required)
2. Secure single-wall vent connections with 3 screws each
3. Verify adequate combustion air supply per code
Testing and Startup:
1. Pressure-test gas and water connections for leaks
2. Fill tank and purge air from lines
3. Test T&P relief valve operation
4. Light pilot, set temperature to 120°F (or per client preference), and confirm burner ignition
5. Validate full operational status
Cleanup and Final Steps:
1. Clear debris from work area
2. Haul away old unit for disposal
3. Conduct final inspection with client walkthrough
Notes:
- Estimate valid for 60 days from issuance
- Includes permit fees (if required)
- Unforeseen issues or additional work will be quoted separately with client approval
- Exclusions: Drywall, paint, stucco, tile, concrete, stone repairs, or existing water damage
- Duration: 3-4 hours, 1 technician
- Warranty: Manufacturer - 6 years parts, 1 year labor; Conejo - 3 years labor
- Financing: 18 months at 0% interest available
- Qualifies for applicable utility rebates and federal tax credits (where available)
MOEN 1225B Cartridge Replacement
Replacement of a MOEN 1225B cartridge in a single-handle faucet to restore smooth operation, with noted risks of cartridge seizure.
Location: Bathroom or Kitchen
Tasks:
Preparation:
1. Shut off water supply to faucet (angle stops or main line).
2. Remove faucet handle by loosening set screw or cap.
3. Set up work area with drop cloth and tools (wrench, MOEN cartridge puller).
Cartridge Removal:
1. Remove retaining clip or nut securing old 1225B cartridge.
2. Use MOEN cartridge puller to extract cartridge, applying steady force.
3. Clean faucet body to remove scale or debris; inspect for damage.
Cartridge Installation:
1. Insert new MOEN 1225B cartridge, aligning tabs per orientation.
2. Secure cartridge with retaining clip or nut.
3. Reattach handle and tighten set screw or cap.
Testing:
1. Turn on water supply and check for leaks at faucet.
2. Test handle for smooth hot/cold operation and no drips.
3. Adjust cartridge alignment if handle motion is stiff.
Cleanup and Final Steps:
1. Wipe down faucet and sink area.
2. Dispose of old cartridge per local regulations.
3. Conduct client walkthrough to demonstrate operation.
Notes:
- Risk: Cartridge may be stuck due to corrosion or scale, potentially damaging faucet body.
- If cartridge cannot be removed safely, full faucet replacement may be required, quoted separately.
- Includes genuine MOEN 1225B cartridge.
- Advise client to test faucet periodically for leaks.
- Estimate valid for 60 days from issuance
- Includes permit fees (if required)
- Unforeseen issues or additional work will be quoted separately with client approval
- Exclusions: Drywall, paint, stucco, tile, concrete, stone repairs, or existing water damage
- Duration: 1-2 hours, 1 technician
- Warranty: 1 year parts and labor
- Financing: 18 months at 0% interest availableCC or check $3776.00
- Date Ranges
- Date Ranges: 2025 - Q4
- HVAC
- Price Ranges
- Price Ranges: -10000
- HVAC: HVAC Install
- Price Ranges: 20001 - 25000
- Date Ranges: 2023 - Q3
- Date Ranges: 2022 - Q2
Kristin and Daniel Bedi, CA
Install Flagship 1354
Sold by Paul
**UPON COMPLETION, PLEASE COLLECT $6,655.00**INSTALL MUST BE COMPLETED BY 3:00 PER CUSTOMER**
Please call when on the way 510-468-9294
Install **TANKLESS ON WILL CALL AT CEDAR PLUMBING
Sales- Greg Jamroz
Turn- Ralph Ortiz
Tankless
Total- $4,350.00 (Office has CC)
Install
Sales- Greg Jamroz
Turn- Brett Sutherland
U/S- horizontal furnace, coil, A/C, ducting, CleanEffects
D/S- horizontal furnace, coil, A/C, CleanEffects
(2) PORTABLE A/C UNITS ARE THIS LOCATION - PLEASE PICK UP AND RETURN TO CVHA-SHOP.
Financing - $35,000.00 (Wells Fargo 48 months no interest)
Marisa to charge card on file (per Greg) - $870.00
Hydro-Jetting, Replacing a 2" wall clean out that will service the Master Bathroom Sink and tub [and stucco repair]
Sold by Bryan C.
Material (listed on estimate for 2" cleanout replacement):
2" ABS Cleanout Tee
2" ABS Cleanout Plug
2" x 10' ABS Pipe
Amount to collect when done: $11,610.00
Please call Daniel 408-506-7422
- Plumbing
- Plumbing: Plumbing Install
- Price Ranges
- Price Ranges: 10000 - 15000
- Date Ranges
- Date Ranges: 2026 - Q1
- Price Ranges: -10000
- Date Ranges: 2024 - Q2
- HVAC
- HVAC: HVAC Install
- Price Ranges: 35001 - 40000
- Date Ranges: 2020 - Q2
Tempus - $26400 - 8/11/23, CA
Installation **CRANE ARRIVAL 9:00AM; DANNY'S CRANE (COULDN'T DO ANY LATER..)
Sales- Ralph
Turn- Nathan
10ton RUUD rooftop package unit
Total due - $26,400.00 (Bill out)
- HVAC
- HVAC: HVAC Install
- Price Ranges
- Price Ranges: 25001 - 30000
- Date Ranges
- Date Ranges: 2023 - Q3
Arlene Raisner - $6400 - 2/3/20, CA
Install
Sales- Greg Jamroz
Turn- N/A
Upflow furnace only.
Deposit: $500.00 (CC)
Total due: $5,900.00 (CC or check, ask Homeowner)
- HVAC
- HVAC: HVAC Install
- Price Ranges
- Price Ranges: -10000
- Date Ranges
- Date Ranges: 2020 - Q1
Customer Testimonials
There are no testimonials at this time. Check back later!