Take a look at our past work!

**PLEASE SEND KRISTA A PICTURE OF WATER HEATER LABEL FOR WARRANTY**Frank gas diagram 8am-10am/same time as electrical/ CX confirmed

10/30 Justin please install pump for Noritz EZ111 tankless water heater

Water heater is causing the home to shakeInstall unsureCustomer is h/o Guard at the gate codePlatinum membership - Please call office with CC Please call 310-270-1742

Install a Noritz EZ111 tankless water heater. this install includes new water lines, expansion tank, two way water valves for proper water flushes, gas line with drip leg, proper exhaust venting, and city permits

CLICK HERE FOR POSSIBLE REBATE OPTIONS

https://www.noritz.com/home-owners/energy-savings/ - 3/4 X 3/4 X 24 WATER HEATER FLEX - Noritz EZ11.1GPM EZ TANKLESS HEATER - 69W43 SENSOR FLAME KIT

Ez 111

With comfort flow tee installed in master bathroom

Remove 50 gallon and haul away

Add 3/4 copper accordingly

Add expansion tank soft ball

Add bonding wire

Add uni strut Using anchor

Add sheet metal to base

Add gas sediment trap

Add condensation neutralizer

Area Drain Spot Reroute ad RepairsSold by Derek10/30 Per Mo's note Complete work in front of homeCost to install a new drain on the back patio in the same location, but rerouting it towards the rear of the home, down the hill and to the culvert. Will utilize the row of bricks, removing them for the trench. Will run pipe down the hill to the left towards the fence.

Conejo does not repair or replace bricks, concrete, vegetation.

Will also repair the root intrusion on the left side system curb level in front of the tree.

Project will require 6-8 hours and 2 technicians.

Amount to collect when done: $3,786.00

Please call Mark when on the way 805-320-7002

**Per Derek job will require 6-8 hours 2 techs**

Sales-JimmyPLEASE UPLOAD WATER HEATER LABEL PIC TO JOB OR SEND TO KRISTA

Drain and remove the old water heater.

Install a new 50 gallon water heater.

Install a new drain pan.

Sheetmetal the base.

Install a new gas flex connector, water connectors, supply ball valve shut-off and quake strap.

Install expansion tank at supply line of water.

Hook T&P valve up to existing copper line.

Tax and permits are included in the price of cost.

6 year tank 6 year parts and 1 year labor warranty - Bradford Water Heater 50 Gal - 50 Gal KitCollect CC or Check $3537.00

Sales-Derek10/29 Derek to go back and install shower cartridge

**PLEASE TAKE A PICTURE OF THE WATER HEATER LABLE AND SEND TO KRISTA**

Shower cartridge price pfister ceramic

40-Gallon Gas Water Heater Replacement

Replacement of an existing 40-gallon gas water heater in a garage with no recirculation pump.

Location: Garage

Recirculation Pump: No

Tasks:

Preparation and Shutoff:

1. Shut off gas supply valve

2. Close main water supply

3. Drain existing water heater to empty tank

Removal of Existing Unit:

1. Disconnect gas line from heater

2. Detach cold and hot water supply lines

3. Remove and dispose of old unit per local regulations

New Water Heater Installation:

1. Position new 40-gallon unit with adequate clearance per code

2. Install new drain pan beneath unit

3. Connect new stainless steel water supply lines (cold and hot)

4. Install 1/4-turn ball valve on cold water inlet

5. Install expansion tank, adjusted to home water pressure (typically 50-60 PSI)

6. Fit new gas shutoff valve on gas line

7. Attach new flexible gas supply line with sediment trap

8. Secure unit with Unistrut mounting and earthquake straps

9. Reconnect to existing T&P relief valve exit point

10. Insulate water supply lines for efficiency

11. Install copper bonding wire from water lines to gas line for grounding

12. Cover base/stand with sheet metal for protection

Venting and Combustion:

1. Install venting per manufacturer’s specs (e.g., double-wall or single-wall as required)

2. Secure single-wall vent connections with 3 screws each

3. Verify adequate combustion air supply per code

Testing and Startup:

1. Pressure-test gas and water connections for leaks

2. Fill tank and purge air from lines

3. Test T&P relief valve operation

4. Light pilot, set temperature to 120°F (or per client preference), and confirm burner ignition

5. Validate full operational status

Cleanup and Final Steps:

1. Clear debris from work area

2. Haul away old unit for disposal

3. Conduct final inspection with client walkthrough

Notes:

- Estimate valid for 60 days from issuance

- Includes permit fees (if required)

- Unforeseen issues or additional work will be quoted separately with client approval

- Exclusions: Drywall, paint, stucco, tile, concrete, stone repairs, or existing water damage

- Duration: 3-4 hours, 1 technician

- Warranty: Manufacturer - 6 years parts, 1 year labor; Conejo - 3 years labor

- Financing: 18 months at 0% interest available

- Qualifies for applicable utility rebates and federal tax credits (where available)CC or Check $3354.00

Installation

Sales- james

Turn- Eric

Duct mod, cat walk

Total due - $3,100.00 (CC or check)