Take a look at our past work!

Installation | **SEAN HAWORTH TO RUN ELECTRICAL 7/5. **PLUMBING TO RUN GAS 7/5

Sales- Greg

Turn- David M 

5TON Horizontal R802VA furnace, coil (relocate to attic), BOVA15 A/C, duct mod

Total - $26,400.00 *Financing; Synchrony*

Sales: JohnReplacement of an existing 50-gallon gas water heater in a garage with no recirculation pump.

Location: Garage

Recirculation Pump: No

Tasks:

Preparation and Shutoff:

1. Shut off gas supply valve

2. Close main water supply

3. Drain existing water heater to empty tank

Removal of Existing Unit:

1. Disconnect gas line from heater

2. Detach cold and hot water supply lines

3. Remove and dispose of old unit per local regulations

New Water Heater Installation:

1. Position new 50-gallon unit with adequate clearance per code

2. Install new drain pan beneath unit

3. Connect new stainless steel water supply lines (cold and hot)

4. Install 1/4-turn ball valve on cold water inlet

5. Install expansion tank, adjusted to home water pressure (typically 50-60 PSI)

6. Fit new gas shutoff valve on gas line

7. Attach new flexible gas supply line with sediment trap

8. Secure unit with Unistrut mounting and earthquake straps

9. Reconnect to existing T&P relief valve exit point

10. Insulate water supply lines for efficiency

11. Install copper bonding wire from water lines to gas line for grounding

12. Cover base/stand with sheet metal for protection

Venting and Combustion:

1. Install venting per manufacturer’s specs (e.g., double-wall or single-wall as required)

2. Secure single-wall vent connections with 3 screws each

3. Verify adequate combustion air supply per code

Testing and Startup:

1. Pressure-test gas and water connections for leaks

2. Fill tank and purge air from lines

3. Test T&P relief valve operation

4. Light pilot, set temperature to 120°F (or per client preference), and confirm burner ignition

5. Validate full operational status

Cleanup and Final Steps:

1. Clear debris from work area

2. Haul away old unit for disposal

3. Conduct final inspection with client walkthrough

Collect: $3,245.00

Installing approximately 1,000 sq. ft of blown-in insulation over existing to R38 value

Tech will be onsite 10-12 to install new iWave.COLLECT - $4,000.00 (Ask homeowner if they would like to use CC on contract)

Installation

Sales- Jesse Cruz

Turn- Eric

4TON horizontal S8X1 furnace/coil, XR14 A/C

Total for this portion - $13,100.00 (CHECK)

Sales- Brice

Turn- N/A

CleanEffects + new return plenum

Total - $2,800.00 (CC or check)

Installation-

Sales- Jesse Cruz

Turn- Georgie 

Running new copper line set

$3,347.50 (Jesse has CC on paperwork)

Replace 50-gallon with 40-gallon water heater

Meeting with Barbara

Customer is H/O

Not Gated

Please collect $2,850

Please call when you are on your way (805) 231-3628

Installation

Sales- Chip

Turn- Dakota4TON upflow R802VA furnace/coil, BOVB18 A/C, Honeywell #T6, 1 CO DETECTOR

Total due - $19,370.00 (Synchrony 12 months)

Installation

Sales- Chip

Turn- N/AAdd on ductless 2 head mini split (outdoor condenser to be wall mounted).

Total due - $13,950.00 (CC or check)