Take a look at our past work!

Sales-Tony**Send Krista water heater label or upload to acct**-Tony will be meeting you 8am-9am to set job up for you--Need to pick up toilets from Home Depot before heading to install; cx has made home depot aware that one of you guys will be picking them up and gave your names-Please confirm toilets are correct one that was ordered-Attached Home depot invoice to the acct-

50-Gallon Gas Water Heater Replacement

Replacement of an existing 50-gallon gas water heater in a garage with no recirculation pump.

Location: Garage

Recirculation Pump: No

Tasks:

Preparation and Shutoff:

1. Shut off gas supply valve

2. Close main water supply

3. Drain existing water heater to empty tank

Removal of Existing Unit:

1. Disconnect gas line from heater

2. Detach cold and hot water supply lines

3. Remove and dispose of old unit per local regulations

New Water Heater Installation:

1. Position new 50-gallon unit with adequate clearance per code

2. Install new drain pan beneath unit

3. Connect new stainless steel water supply lines (cold and hot)

4. Install 1/4-turn ball valve on cold water inlet

5. Install expansion tank, adjusted to home water pressure (typically 50-60 PSI)

6. Fit new gas shutoff valve on gas line

7. Attach new flexible gas supply line with sediment trap

8. Secure unit with Unistrut mounting and earthquake straps

9. Install watts 210

10. Insulate water supply lines for efficiency

11. Install copper bonding wire from water lines to gas line for grounding

12. Cover pan outlet and install water alarms

Venting and Combustion:

1. Install venting per manufacturer's specs (e.g., double-wall or single-wall as required)

2. Secure single-wall vent connections with 3 screws each

3. Verify adequate combustion air supply per code

Testing and Startup:

1. Pressure-test gas and water connections for leaks

2. Fill tank and purge air from lines

3. Test T&P relief valve operation

4. Light pilot, set temperature to 120°F (or per client preference), and confirm burner ignition

5. Validate full operational status

Cleanup and Final Steps:

1. Clear debris from work area

2. Haul away old unit for disposal

3. Conduct final inspection with client walkthrough

Notes:

- Estimate valid for 60 days from issuance

- Includes permit fees (if required)

- Unforeseen issues or additional work will be quoted separately with client approval

- Exclusions: Drywall, paint, stucco, tile, concrete, stone repairs, or existing water damage

- Duration: 3-4 hours, 1 technician

- Warranty: Manufacturer - 6 years parts, 1 year labor; Conejo - 3 years labor

- Financing: 18 months at 0% interest available

- Qualifies for applicable utility rebates and federal tax credits (where available)

Emergency shut off for toilet:

Cut open drywall and extend copper line

Install new escutcheon and angle stop

Install new supply line

Customer supplied toilets:

Toilet Installation Customer Provided

Installation of a customer-provided toilet, including new wax ring, mounting bolts, stainless steel supply line, and caulking, with assessment of flange condition. No warranty on customer-provided parts or fixtures.

Location: Bathroom

Tasks:

Preparation and Shutoff:

1. Shut off water supply at the angle stop valve.

2. Remove old toilet (if present) by disconnecting supply line and bolts.

3. Inspect flange for damage or wear, noting condition for potential repair.

New Toilet Installation:

1. Place new wax ring on flange or toilet base for secure seal.

2. Position customer-provided toilet over flange, aligning with mounting holes.

3. Secure toilet to floor with new corrosion-resistant mounting bolts.

4. Connect new stainless steel supply line from angle stop to toilet tank.

5. Apply silicone caulk around toilet base for a clean, sealed finish.

Testing and Adjustment:

1. Turn on water supply and fill tank, checking for leaks at supply line and base.

2. Flush multiple times to verify operation and seal integrity.

3. Adjust fill valve to set water level per manufacturer specs, if provided.

Cleanup and Final Steps:

1. Wipe down toilet and surrounding area to remove debris or caulk residue.

2. Dispose of old toilet (if applicable) per local regulations.

3. Conduct client walkthrough to demonstrate flush and stability.

Notes:

- Customer-provided toilet must be compatible with existing plumbing.

- No warranty on customer-provided parts or fixtures; labor warranty applies to installation only.

- Flange repairs, if needed, will plantar fasciitis be quoted separately after assessment.

- Advise client to monitor for leaks over next 24 hours.

- Estimate valid for 60 days from issuance

- Includes permit fees (if required)

- Unforeseen issues or additional work will be quoted separately with client approval

- Exclusions: Drywall, paint, stucco, tile, concrete, stone repairs, or existing water damage

- Duration: 2-3 hours, 1 technician

- Warranty: Conejo - 1 year labor only

- Financing: 18 months at 0% interest available

CC or check $5667.80

40-gallon Bradford White Water Heater Installation

12/10 Justin F. please take a pic**Please send pic to Krista of water heater label or upload to acct**12/10 Go back to property and re install water heater in proper place

Sold by Jimmy

Conejo home services will replace 30 gallon water heater in mobile home unit

Drain and remove the old water heater.

Install a new 40 gallon water heater.

Install a new drain pan.

Sheetmetal the base.

Install a new gas flex connector, water connectors, supply ball valve shut-off and quake strap.

Install expansion tank at supply line of water.

Hook T&P valve up to existing copper line.

Tax and permits are included in the price of cost.

6 year tank 6 year parts and 1 year labor warranty

Amount to collect when done: $3,294.00

Please call Chris when on the way 805-210-0886

***ANDREW WILL EMAIL MATERIAL SHEET TO COLE***

Installation

Sales- Brice

Turn- N/A

3TON Upflow R801 furnace, coil, add on Innovair18-see rA/C, line set, electrical, ducting 7 runs, supply registers

Total for this portion - $20,000.00 (CC OR CHECK)

Installation **7AM PRE. **CRANE ARRIVAL 9:30-10:30

Sales- Jesse

Turn- Juan

3TON upflow R801 furnace/coil, Innovair GOV36 A/C on roof, Honeywell #T6

Deposit - $1,000.00 (CC)

Total due - $12,500.00 (CC or check)