Take a look at our past work!

Sales-Bill**CALL THE CX WHEN YOU ARRIVE SO HE CAN REMOTELY OPEN THE GARAGE FOR YOU**

SEND KRISTA PIC OF THE WATER HEATER LABEL OR UPLOAD TO THE ACCT

Drain and remove existing water heater

Clean and prep area

Install backing, grounding and strapping

Install smitty pan

No sheet metal needed

Install new 6 year 40 gal Bradford to todays code requirements

Run 30’ of T&P line infront of the Ait handler along garage wall to and outside source

Rework 3” venting so it’s not touching the ducting

6 year manufacturer warranty on tank

3 year manufacturer warranty on parts and labor

CVHS provides a 3 year warranty on parts and labor

Test and light unit

Haul all trash and debris away

18 month 0% financing available

CC OR CHECK $3448.70

Installation **7AM START TIME

Sales- Greg

Turn- Juan

Bedrooms- 5TON horizontal R802VA furnace/coil, Innovair 18-slim, CleanEffects, disconnect

Main House- 5TON horizontal R802VA furnace/coil, Innovair 18-slim, CleanEffects, new zone board, new return, new disconnect.

Financing - $35,000.00 *Synchrony 12 months*COLLECT CHECK - $12,950.00

Shut water off to the house and drain down a bit

Shut off both circ pumps at the timers

Left side tankless-

Cut and install a 3/4” ball valve on the incoming cold horizontal piping.

Replace both the hot and cold shut off valves to the tankless and pipe in as needed

Right side tankless-

Cut and install a 1” ball valve and repair coupling on the incoming cold vertical piping

Replace both the hot and cold shut off valves to tankless and pipe in as needed

NOTE- There are no cold water isolation valve to units. Per code. Isolation valves on the cold side before the tanklesses need to be installed

Replace both sets of shut offs to both tankless (both sets are frozen and have leaked)

Platinum maintenance-

Flush both tankless after work is completed

Pricing reflects platinum discount

Amount to collect: $1,142.80

Installation

Sales- Jesse

Turn- Nathan

4ton Horizontal ML180E furnace, coil, Innovair square A/C, ducting 11-14 runs, NUVE thermostat

Total due - $21,650.00 *CHECK*

40- Gallon Bradford White Water Heater Install. (PENDING MATERIAL SHEET)Sold by Stacie**PLEASE TAKE A PIC OF WATER HEATER LABEL AND SEND TO KRISTA OR UPLOAD TO ACCT**

Replace existing tank water heater with new Bradford white 40 gallon tank water heater in garage location.

Install new stainless steel water heater flex connectors.

Install new ball valve shut off.

Install new 2.1 gallon thermal expansion tank.

Install new temperature/pressure relief valve and drain to exterior.

Install new water heater earthquake strapping.

Install new unistrut mounting system.

Install new gas shut off valve, gas flex, and sediment trap.

Install new sheet metal base and front on stand.

Install new water heater drip pan.

City permits included.

0% 18 months no terms financing is available.

Conejo 3 year parts/labor warranty.

Manufacturer 6 year parts/tank warranty. 10 year warranty available within 30 days of purchase.

Conejo does not warranty existing customer equipment, fixtures, or piping systems.

Conejo does not repair or replace damaged drywall, paint, stucco, or existing water damage nor are they included in this estimate.

**Amount to collect when done: $3,294.00**

Please call Bob when on the way 805-341-3480

Sales- DerekPer restorez please be careful moving the equpiment around

Cost to repipe the freshwater system of the home with new type L copper piping. Will install all new straight stops and laundry Bibbs. Will install new stainless steel supply lines. Will connect to the two shower valves in the wall. Will connect to a new laundry box in the wall behind the washer. The deck tub set has access under the right side lavatory sink. All other fixtures are through the floor.

Total fixtures:

Hallway bathroom:

Lavatory

Toilet

Shower

Master bathroom:

Two lavatories

Deck tub

Shower

Toilet

Kitchen sink

Bar sink

Laundry box

Water Heater

Two hose bibbs

Hallway shower has access panel in laundry room

Master shower will require drywall cut in guest bedroom closet

Laundry box will require drywall cut behind washer

Conejo does not replace or repair drywall, paint, stucco, etc.

Full Home Repipe Copper

Complete repipe of home plumbing using copper piping to replace all water lines, ensuring superior durability and water quality.

Location: Whole Home

Tasks:

Assessment and Preparation:

1. Map existing plumbing to plan copper routing.

2. Shut off main water supply to home.

3. Set up work areas with drop cloths and tools (pipe cutter, torch, solder).

Pipe Removal:

1. Remove all existing water lines (e.g., galvanized, PEX).

2. Dispose of old piping per local regulations.

3. Cap open lines to prevent debris entry during work.

Copper Installation:

1. Install copper manifold system for hot and cold water distribution.

2. Route new copper piping (1/2-inch to 1-inch, per demand) to all fixtures.

3. Solder copper fittings and secure piping with hangers per code.

Testing:

1. Turn on water supply and pressure-test entire system for leaks.

2. Run water through all fixtures to verify flow and pressure.

3. Inspect all solder joints with leak detector solution.

Cleanup and Final Steps:

1. Wipe down work areas and remove debris.

2. Dispose of old materials per local regulations.

3. Conduct client walkthrough to demonstrate functionality.

Notes:

- Copper offers unmatched durability and water purity.

- Wall or floor access repairs quoted separately.

- Advise client to monitor water pressure post-repipe.

- Estimate valid for 60 days from issuance

- Includes permit fees

- Unforeseen issues or additional work will be quoted separately with client approval

- Exclusions: Drywall, paint, stucco, tile, concrete, stone repairs, or existing water damage

- Duration: 1-2 days, 4 technicians

- Warranty: 10 years parts and labor

- Financing: 18 months at 0% interest available

CC or check 14513.00