Take a look at our past work!

Installation ***FRANCISCO WILL PERFORM HIS OWN PRE / BOBBY WILL STOP BY TO HELP

Sales- Jesse

Turn- Alex Q

Ducting, 11 runs, new drain lines, dual wall flue vent, dampers, sediment trap

Total due - $8,600.00 (CC)

***TAKE PHOTO OF THE LABEL AND SEND IT TO KRISTA FOR WARRANTY***

50-Gallon Gas Water Heater ReplacementSold by Kevin

Replacement of an existing 50-gallon gas water heater in a garage with no recirculation pump.

Location: Garage

Recirculation Pump: No

Tasks:

Preparation and Shutoff:

1. Shut off gas supply valve

2. Close main water supply

3. Drain existing water heater to empty tank

Removal of Existing Unit:

1. Disconnect gas line from heater

2. Detach cold and hot water supply lines

3. Remove and dispose of old unit per local regulations

New Water Heater Installation:

1. Position new 50-gallon unit with adequate clearance per code

2. Install new drain pan beneath unit

3. Connect new stainless steel water supply lines (cold and hot)

4. Install 1/4-turn ball valve on cold water inlet

5. Install expansion tank, adjusted to home water pressure (typically 50-60 PSI)

6. Fit new gas shutoff valve on gas line

7. Attach new flexible gas supply line with sediment trap

8. Secure unit with Unistrut mounting and earthquake straps

9. Reconnect to existing T&P relief valve exit point

10. Insulate water supply lines for efficiency

11. Install copper bonding wire from water lines to gas line for grounding

12. Cover base/stand with sheet metal for protection

Venting and Combustion:

1. Install venting per manufacturer's specs (e.g., double-wall or single-wall as required)

2. Secure single-wall vent connections with 3 screws each

3. Verify adequate combustion air supply per code

Testing and Startup:

1. Pressure-test gas and water connections for leaks

2. Fill tank and purge air from lines

3. Test T&P relief valve operation

4. Light pilot, set temperature to 120°F (or per client preference), and confirm burner ignition

5. Validate full operational status

Cleanup and Final Steps:

1. Clear debris from work area

2. Haul away old unit for disposal

3. Conduct final inspection with client walkthrough

Notes:

- Estimate valid for 60 days from issuance

- Includes permit fees (if required)

- Unforeseen issues or additional work will be quoted separately with client approval

- Exclusions: Drywall, paint, stucco, tile, concrete, stone repairs, or existing water damage

- Duration: 3-4 hours, 1 technician

- Warranty: Manufacturer - 6 years parts, 1 year labor; Conejo - 3 years labor

- Financing: 18 months at 0% interest available

- Qualifies for applicable utility rebates and federal tax credits (where available)

Amount to collect: $3943.00

Please call Ruth 805-495-1782

Installation **7AM PRE **SETUP FOR DUAL FUEL

Sales- Brice

Turn- N/A

3TON horizontal R802VA furnace/coil, Innovair 18-seer skinny, NUVE thermostat.

Total due- $20,998.00 (CC or CHECK)

Installation

Sales- Chip

Turn- Alfredo

5TON upflow coil, Bryant 16-seer, ducting 8 runs

Total due- $16,000.00 (CHECK)

InstallSales- TracyWater line re-routeTotal due - $4,679.00 (CC or CHECK)